Приветствую!
Коллеги, а кто-нибудь может объяснить такую вещь: в EXOS Concepts Guide
для версий 12.4 и 12.6 на страницах 215 и 238 соответственно прямо сказано:
"The L3 and custom keywords are not supported on Summit X150, X250e, X350, X450a, and X450e
series switches. The L3_L4 keyword is not supported on Summit X150 and X350 series switches.
"
Имеется два идентичных свитча: X350-48t.
На одном 12.4.3.5 и:
sw7-gdr.ki.4 # show sharing
Load Sharing Monitor
Config Current Agg Ld Share Ld Share Agg Link Link Up
Master Master Control Algorithm Group Mbr State Transitions
==============================================================================
5 LACP L3_L4 5 - R 97
L3_L4 6 - R 96
L3_L4 7 - R 98
L3_L4 8 - R 95
==============================================================================
sw7-gdr.ki.5 # enable sharing 5 grouping 5-8 algorithm address-based ?
<cr> Execute the command
health-check link aggregation group handled by health-check application
L2 Based on layer 2 MAC (default)
L3_L4 Based on layer 3 IP and layer 4 port
lacp link aggregation group handled by LACP
На другом 12.6.3.2 patch1-2 и:
* sw3-ki.6 # enable sharing 41 grouping 41-44 algorithm address-based ?
<cr> Execute the command
health-check link aggregation group handled by health-check application
L2 Based on layer 2 MAC (default)
lacp link aggregation group handled by LACP
И где правда-то?
--
Kind Regards, Alexander Shikoff
AMS1-UANIC