Приветствую! Коллеги, а кто-нибудь может объяснить такую вещь: в EXOS Concepts Guide для версий 12.4 и 12.6 на страницах 215 и 238 соответственно прямо сказано: "The L3 and custom keywords are not supported on Summit X150, X250e, X350, X450a, and X450e series switches. The L3_L4 keyword is not supported on Summit X150 and X350 series switches. " Имеется два идентичных свитча: X350-48t. На одном 12.4.3.5 и: sw7-gdr.ki.4 # show sharing Load Sharing Monitor Config Current Agg Ld Share Ld Share Agg Link Link Up Master Master Control Algorithm Group Mbr State Transitions ============================================================================== 5 LACP L3_L4 5 - R 97 L3_L4 6 - R 96 L3_L4 7 - R 98 L3_L4 8 - R 95 ============================================================================== sw7-gdr.ki.5 # enable sharing 5 grouping 5-8 algorithm address-based ? <cr> Execute the command health-check link aggregation group handled by health-check application L2 Based on layer 2 MAC (default) L3_L4 Based on layer 3 IP and layer 4 port lacp link aggregation group handled by LACP На другом 12.6.3.2 patch1-2 и: * sw3-ki.6 # enable sharing 41 grouping 41-44 algorithm address-based ? <cr> Execute the command health-check link aggregation group handled by health-check application L2 Based on layer 2 MAC (default) lacp link aggregation group handled by LACP И где правда-то? -- Kind Regards, Alexander Shikoff AMS1-UANIC